£1,266.80 £1,055.67

Details

Megaflo 125 Litre Indirect Unvented Cylinder

The Megaflo Eco 125i Unvented Cylinder works as part of an indirect system to store up to 145 litres of hot water. It is ideally suited for 1-2 bedroom properties with 1 bath & shower.

As an unvented cylinder it provides a powerful hot water performance by using your properties mains water pressure.

Made from stainless steel, the Heatrae Megaflo Eco 125 litre model is built to last and even comes with a fabulous life time warranty.

With fantastic levels of heat and water retention, the Heatrae megaflo Eco 125i has been built with efficiency in mind and is able to handle up to 15 bars of pressure, up to 5 times more than standard operating pressure levels.

Dimensions:

  • Height: 1102mm
  • Diameter: 579mm

Performance

  • Capacity: 125 litres 
  • Element rating at 240V: 1x3
  • Coil rating: 18.3kW
  • Weight (when empty): 31kg
  • Weight (when full): 180kg 

Key features of Megaflo Eco 125 Litre:

  • Coil-in-coil' heat exchanger
  • Insulated outer casing -  increased heating efficiency & pressure relief
  • Unique floating baffle system allows water expansion
  • No anode -  Removes need to replace or maintain
  • Easy to install
  • Immersion heater design increases levels of hot water
  • Titanium immersion heater
  • Reduction in levels of cold water mixing with hot water
  • Enjoy flowrates up to 20% higher than usual due to the Water inlet controls
  • Improved performance at low pressures down to 1 bar
  • Lifetime manufacturer warranty.
  • Manufactured in UK.

Pack Includes:

  • 1 x Megaflo Eco 125 Litre Unvented Indirect Cylinder
  • Factory fitted immersion heater and thermal controls.
  • Long-life superloy 825 alloy sheathed elements
  • Cold water inlet control kit: 0.3MPa (3 bar) pressure reducing valve, 0.8 (8 bar) pressure reducing valve (BS EN 1567, BS EN1491, EN13959), 1/4 turn isolating valve, line strainer, non-return valve, drain valve with hose connector, nuts and olives
  • Factory fitted temperature and pressure relief valve set at 90 degrees / 1Mpa (10 bar) (BS EN 1490)
  • T&P valve insulation kit
  • 15/22mm tundish
  • Additional thermostat and thermal outlet
  • Wiring centre
  • 22mm 2 port motorised valve